1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
3 OF 4
DAZZLE 24
™
24V RGB LED TAPE LIGHT
®
IG082514-2.4
–
+
G
V+
B
R
–
+
–
+
–
+
RGB CLICKTIGHT
™
Connectors
Cut the tape at the line indicated with the scissors icon. Close the CLICKTIGHT™ latch to ensure connecon.
When ready for mounng, peel o the 3M™ adhesive backing
of the tape and tear o along the connector tray edge. Mount
tape light and ulize a wiring harness to secure lead wires.
Open the CLICKTIGHT™ latch and note the +/- polarity markings.
Firmly insert the tape light into the connector tray with the
3M™ adhesive backing sll intact to the tape. Ensure the
contact/solder points of the tape are directly underneath the
metal placement tabs of the connector.
These instrucons apply only to RGB CLICKTIGHT™ Connectors (does not apply to solid color CLICKTIGHT™ Connectors). Never cut tape aached to a
live circuit.
Wiring Harness 3M™ Adhesive
+
+
Prior to troubleshoong, ensure all items are a compable system and main power is turned ON.
Troubleshooting
Shi in brightness and/or kelvin
• Review maximum series run limits. Exceeding these limits will cause
excess voltage drop, decreasing brightness and/or kelvin as the run is
extended.
Some LEDs are not funconal
• Ensure all connecons have been properly aached. Ensure xture has
not been bent excessively, which may cause components and solder to
detach from the circuit board.
Lights are ickering
• Ensure a compable driver is installed. Ensure the pre-set mode of the
controller is not on a dynamic mode. Ensure Data +/- connecons of
DMX systems are not reversed. If lights connue to icker, check for
loose connecons. Ensure tape light connectors are properly aached.
Lights are turning on/o repeatedly
• Ensure driver is not overloaded. An overloaded driver will trip the
internal auto-reset (of driver) repeatedly, turning the system on/o.
CLICKTIGHT™ Connector Troubleshoong
• Ensure compable CLICKTIGHT™ models are aached. Tape lights vary
in width and require specic connectors. Contact your supplier for
addional informaon.
• Tape light is polarity sensive. Ensure the +/- markings of the CLICKTIGHT™
connector is aligned with the +/- markings of the tape. If polarity is
backwards, reverse the lead wire connecon or detach tape from
CLICKTIGHT™ connector and reaach opposing end of tape to connector.
(4 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji